# Raspberry PI quick start installation support
**URL:** https://community.learningequality.org/t/raspberry-pi-quick-start-installation-support/1616
**Category:** Kolibri
**Created:** [July 19, 2020, 6:48pm UTC](https://community.learningequality.org/t/raspberry-pi-quick-start-installation-support/1616 "2020-07-19T18:48:46Z")
**Posts on this page:** 2
**Page:** 1
### Author:  [@PapayaGuy](https://community.learningequality.org/u/PapayaGuy)
#### Post date: [July 19, 2020, 6:48pm UTC](https://community.learningequality.org/t/raspberry-pi-quick-start-installation-support/1616/1 "2020-07-19T18:48:46Z")
I am trying to install Kolibri on my Raspberry PI using the quick start method. It all went fine, burning the image to the SD, booting the PI, letting it run of 5 minutes, but after entering the username (pi) and password (kolibrifly) I am not getting any further. The whole screen is just one giant command prompt staring at me, saying “pi@kolibri” with a blinking underscore waiting for me to do something. I am sorry if I have missed something really obvious here, but it feels like the documentation just ends in the middle of the setup, and I have no idea where to go from here. If someone can please advise me what to do next, I would be grateful. Again, it feels like this should be really simple, but the documentation on this is rather stub.
---
### Author:  [@PapayaGuy](https://community.learningequality.org/u/PapayaGuy)
#### Post date: [July 21, 2020, 7:01am UTC](https://community.learningequality.org/t/raspberry-pi-quick-start-installation-support/1616/2 "2020-07-21T07:01:18Z")
Oh, I get it. Kolibri is installed with Raspberry Lite so there isn’t supposed to be a GUI. I guess that should be obvious, but maybe its worth just mentioning in the documentation. Not everyone booting a PI for the first time will be intimately knowledgeable about the Raspberry pi OS. I’ll reinstall the Raspberry Pi OS and do the manual Kolibri install then.